Choosing wax and wicks for teacup candles

Updated 22 November 2026

Some links on this page are affiliate links. If you buy through them we may earn a small commission, which doesn't change the price you pay.

In short

  • Container soy wax is the easiest to work with in teacups.
  • The right wick depends on the cup's width, the wax and how much fragrance you use.
  • Do a test burn. The melt pool should reach the edge of the cup within about three hours.
  • Soot and a tall flame mean the wick is too big. Tunnelling means it's too small.

Supplies

Container soy wax flakes

Look for wax sold for container candles, as it holds to the sides of the cup and burns slowly.

Pre-tabbed cotton wicks

Wicks with a metal tab already fixed. Buy a mixed pack of sizes until you know what suits your cups.

Wick stickers and centring bars

Stickers hold the wick to the bottom of the cup; a centring bar keeps it upright while the wax sets.

Candle fragrance oils

Use oils made for candles. Essential oils often fade or are not safe at melting temperatures.

Wax and wick choice decide whether a teacup candle burns evenly or leaves a thick ring of wax stuck to the sides. The cup itself doesn’t change much about the method, but china holds heat differently from glass, and teacups are wider and shallower than most candle jars, so it’s worth getting the combination right.

Wax

Container soy wax. This is what most people use for teacup candles. It melts at a fairly low temperature, holds fragrance well, sticks to the sides of the cup and is easy to clean off with hot water. Make sure you buy a wax described as a container wax rather than a pillar wax. Pillar waxes are harder and designed to stand on their own, and they shrink away from the cup.

Rapeseed wax. A common choice for UK makers because the rapeseed is grown here. It behaves a lot like soy and is often sold as a blend with it.

Coconut and coconut blends. Creamy and smooth on top with a good scent throw, but usually more expensive. Often blended with soy or rapeseed.

Paraffin. Cheap and very good at throwing scent, and it gives a glossy finish. It does tend to soot more if the wick is a bit too big, and a lot of buyers now look for plant waxes.

Beeswax. Burns hot and slow with a natural honey smell. It’s harder to wick in a wide cup and is often mixed with another wax. Pure beeswax is expensive for a beginner’s project.

Wicks

Most teacup candles use flat-braided cotton wicks with a metal tab at the bottom. Wick series have names like ECO, CD, HTP and LX, and each comes in a range of sizes. Each series burns slightly differently, but any of them can work. The main thing is picking the right size within a series.

Wooden wicks are popular for their crackle, but they need a bit more trial and error in a round cup and can be fussy with soy.

Sizing a wick for a teacup

Measure the inside width of the cup at the level the wax will come up to. Then look at your wick supplier’s sizing chart for your wax type. The charts are a starting point. Strong fragrance loads, dyes and the shape of the cup all change how a wick behaves.

For cups wider than about 9cm, one wick may not be able to melt all the way to the edge. Two smaller wicks set apart can work better.

The test burn

The only reliable way to check a wick is to burn a test candle. Let it cure first if it’s scented, then light it and watch it for three to four hours.

Write down the cup size, wax, fragrance load and wick for each test. It’s tedious, but after a few rounds you’ll know what works for the cups you use most.